What Size Hardware Does Bulldog Collar-Lok Adjustable Channel Mount Coupler part # BDA2563C0317 Use

Question

Question:

WHAT SIZE BOLTS ON THE BULLDOG ADJUSTABE TRAILER COUPLER

asked by: JUAN V

0

Expert Reply:

The Bulldog Collar-Lok Adjustable Channel Mount Coupler part # BDA2563C0317 uses 5/8" diameter hex head bolts with a grade 5 rating. If you need these, we have the 3 Position Channel and 5 Position Channel Bolt and Nut Kit part # 337B9020 which will work fine.

expert reply by: Jameson C

0

Answer 1

Most trailer jacks like the Lippert #LC285318 only use one wire. That wire provides the power and the assembly grounds through the mounting hardware of the jack. It's hard to tell what's going on with the electric tape and splice connector I…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

It sure does Steve! Our 3,500 lbs etrailer Electric Trailer Jack w/ Tongue Weight Scale item #e43KV also comes in a 5,000 lbs capacity. We have two different options depending on how you want to power it that I have listed below: Wired to Trailer -…

view full answer...

Answer 9

Hi Scott, thanks for reaching out. A great replacement for the 3,500-lb Lippert jack on your Jayco 32BHDS is the etrailer Electric Trailer Jack – A-Frame – 18" Lift – 3,500 lbs #e23ZV. It’s a bolt-on swap with the same capacity, upgraded…

view full answer...

Answer 10

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

What Size Hardware Does Bulldog Collar-Lok Adjustable Channel Mount Coupler part # BDA2563C0317 Use

Products Featured in This Question

Continue Researching