Dimensions Of Replacement Rubber Piston Seal # DE35FR

Question

Question:

What is the dimensions of the seal for your Deemax brake caliper 3500-6000lbs. I’m looking for a caliper seal that will work for a 66mm 2.59” bore. Thanks

asked by: Riaan R

0

Expert Reply:

The Replacement Rubber Piston Seal # DE35FR has an outer diameter of 2-1/2" with a thickness of 1/8".

expert reply by: Bud M

0

Answer 1

You will need the DeeMaxx Ceramic Brake Pads with Stainless Steel Back Plates #DE98VR to fit the DeeMaxx Disc Brake Kit DBSO-6K-MAXX #DE82FR. We also have the Stainless Steel Caliper #DE58VR if you want to upgrade your caliper.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 5

EZ Lube Dust Caps, like #DC200L-DCRP, have a rubber plug that can be removed to access the zerk fitting. The rubber plug can be removed by gently prying it up with a flathead screwdriver. If your dust cap is in good condition and you want to avoid…

view full answer...

Answer 6

The caliper pins do not need lubrication on a trailer. I've attached a video and an article on installing disc brakes for you to take a look at. Although it wouldn't hurt anything if they are lubricated either.

view full answer...

Answer 7

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 8

The Dexter 12K oil bath axles can be changed over to grease without any issues. The oil does keep the bearings lubricated well, but there is a much higher risk of leaking which leads to a much higher risk of failure. I'd personally move to grease…

view full answer...

Answer 9

I spoke with my contact at Dexter and was able to obtain the technical drawing for the Trailer Hub Assembly, #8-214-5. Keep in mind that this hub was designed to fit a spindle from a 10K Dexter axle. I have attached this drawing for you. We do offer…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

People do use electric brakes on a boat trailer but it is not the best idea to do so because of the volatile relationship between water and electricity. You will need to make sure and unplug the trailer from the tow vehicle before submerging the…

view full answer...

Dimensions Of Replacement Rubber Piston Seal # DE35FR

Product Page this Question was Asked From

Continue Researching