What is the Mounting Hole Spacing on the Optronics Trailer License Plate Light LP71CB?
Updated 11/18/2023 | Published 11/17/2023
Question:
LP71CB light dimensions between screw holes.
asked by: Russell L
0
Expert Reply:
There is 2-5/8" between the screw holes on the Optronics Trailer License Plate Light item # LP71CB.
I have linked a diagram below with additional measurements.
expert reply by:
Jerred H
0
Optronics Trailer License Plate Light
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Optronics Trailer License Plate Light - Incandescent - Surface Mount - Chrome - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/8L x 2-3/8W Inch
- White
- Optronics
more information >
Continue Researching
- Shop: Peterson Snap-In License Plate Light - Submersible - Round - Chrome Plated - Clear Lens
- Shop: Optronics Trailer License Plate Light - Incandescent - Surface Mount - Chrome - Clear Lens
- Q&A: Replacement LED Marker/Clearance Lamps for Peterson PM130 on 1998 4Star Horse Trailer
- Q&A: Recommended Round LED License Plate Light Similar to Optronics Light with Mount Ears
- Q&A: What Bulb Does The Optronics Round Trailer License Plate Light With Mount Ears Use?
- Q&A: What Brake Controller For 2020 Chevy Colorado & Is There Plug-In Harness
- Q&A: Installing a Trailer Brake Controller on a 2004 Toyota Highlander with Tow Package
- Q&A: Comparing Bearing Buddy and Kodiak Red Eye Trailer Bearing Protectors
- Q&A: Which B&W Fifth Wheel to Gooseneck Adapter Is Best For Towing My Trailer?
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Lighting Requirements
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Determine Tire/Wheel Diameter
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: Rust Prevention