Recommended Brake Controller and Wiring Harness for a 2023 Fleetwood Fortis on a F53 Chassis

Question

Question:

Hi, I am looking to buy the Prodigy 2 brake controller and the wiring harness for a 2023 Fleetwood Fortis class A RV on the F53 Ford chassis. Can you tell me which wiring harness adapter I need? Thanks

asked by: Adam A

0

Expert Reply:

There is no brake controller port to plug in an adapter on your 2023 Fleetwood Fortis that was built on a F53 chassis. The Tekonsha Prodigy P2 Trailer Brake Controller item # 90885 will have to be hardwired in with the included wiring harness.

expert reply by: Jerred H

0

Answer 1

The Curt #C51180 will work just fine with a vehicle that is equipped with an OEM or aftermarket brake controller. The Echo will not receive any output from the existing controller, as the Echo doesn't have a pin to receive any output from the…

view full answer...

Answer 2

Hi Dorothy, The Seaflo Diaphragm Pump #SE58FR would be a compatible replacement for your Shurflo 4008-101-F65, but it has a lower psi rating so you'd see a bit of a drop in pressure. Instead I recommend going with the Seaflo #SE57FR. This unit…

view full answer...

Answer 3

To replace your Shurflo 2088-422-174 fresh water pump, I recommend the Flow Max RV Fresh Water Pump #LC689052 instead of the HydroMax RV Fresh Water Pump #P25201 because the Flow Max will draw a maximum of 8 amps, as opposed to the 10 amps of the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 10

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 11

Hi Donny; after looking at several videos of the trailer it does appear to have a 6 on 5-1/2 bolt pattern with ST225/75R15 tires. The Goodyear Endurance ST225/75R15 Radial Tire w/ 15" Eagle Aluminum Wheel #GY97QB will be a direct fit.

view full answer...

Answer 12

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Recommended Brake Controller and Wiring Harness for a 2023 Fleetwood Fortis on a F53 Chassis

Continue Researching