Replacement Trailer Tail Light Recommendations for Bargman 94 Series Lights
Published 10/17/2023 >
Products Featured in This Question
Question:
I have a set of Bargman SAE-AILRST-94 tail lights on my trailer that are going out corroded terminals. I would like to replace just the electrical components as the fixture is riveted to the PVC mody of the trailer and the back side is inaccessible. Do you carry just the socket and bar for this fixture? I need both sides including the driver-side with the license plate light.
asked by: Ron
Expert Reply:
It looks like this light series has been discontinued so your best bet is to replace the entire assembly on either side of your trailer - you'll just have to remove the current rivets and install new rivets with new light assemblies and for that I recommend the following from Peterson:
- Driver Side # V457L
- Passenger Side # V457
These lights measure 8-13/16" long x 5-1/16" tall x 2-3/4" thick so they'll be a little larger than what you currently have which will be a good solution for hiding the weathering from the other set of lights. I've attached some review videos for you to check out.
Product Page this Question was Asked From
Peterson Trailer Tail Light w/ License Bracket - 5 Function - White Base - Red Lens - Driver Side
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- License Plate
- Marker
- Rectangle
- Surface Mount
- Incandescent Light
- 8-13/16L x 5-1/16W Inch
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Search Results: 8~407
- Shop: Trailer Hitch
- Article: Trailer Lighting Requirements
- Q&A: Center Cap for 15 Inch Trailer Wheel That is 10-1/4 Inches Inside Diameter
- Q&A: Which Baby Moon Cover Fits Over Mounting Tabs that are 10-1/4 inch in Diameter
- Q&A: Can I Replace My 5" F0S05TASF Furrion Screen for the 7" Monitor for Furrion Vision S?
- Q&A: Will A 5-1/2" SnapPad Fit A 5.37" Diameter Jack Foot
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole
- Q&A: Recommended Caster Wheel for Old Fulton Jack with 1-5/8 Inch Inner Tube Diameter?
- Q&A: Need Replacement For Atwood Propane Detector Model LP-DRW 36720
- Article: Trailer Tire Sizing
- Article: Hitch Adapters and Extenders
- Article: Converting Your RV Water Heater to Tankless
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Troubleshooting 4 and 5-Way Wiring Installations




