Is The Red "N" Tacky Grease From Lucas Okay to Use on Travel Trailer Wet Bolts?
Updated 05/28/2025 | Published 10/11/2023 >
Question:
hello is the red n tacky grease by lucas ok for my wet bolts on my travel trailer? thanks
asked by: Susan S
0
Expert Reply:
Yes, your Red "N" Tacky grease is okay to use for the wet bolts on your travel trailer. Do note this is an EP grease like the LubriMatic # LM54FR and should not be mixed with other types of grease. If there is another grease on your wet bolts already and you are unsure you will want to remove the bolts and clean out the grease before adding the new grease.
expert reply by:
Bud M
0
Product Page this Question was Asked From
LubriMatic Moly EP Grease - 14-oz Cartridge
- Lubricants Sealants Adhesives
- Grease
- Multi-Purpose Grease
- Moly EP Grease
- 14 oz
- LubriMatic
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: affirm
- Search Results: bug screen water heater
- Search Results: tst~507
- Search Results: tpms sensor
- Search Results: trailer leaf springs
- Search Results: leaf spring bushing
- Search Results: gooseneck stabilizer tripod
- Shop: Big Truck Big RV Tongue Weight Scale for Trailers - 1,000 lbs
- Shop: Lippert AP Kit - Tandem Axle Road Armor Wet Bolts and Shackles
- Q&A: Will The TST-507-R Signal Booster Help With Signal Loss On The Passenger Side Of My 2023 Ford F-450?
- Shop: MORryde Rubber Equalizers for Triple Axle Trailers - 35" Wheelbase - 8K
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Video: A Closer Look at the Power Mountain Tallboy Off-Road Bottle Jack
- Video: Installation Guide for the Lippert AP Kit on a 2022 Grand Design Imagine Travel Trailer
- Shop: RV Propane Gas Detector - 12 Volt - 2 Wire - Black
- Video: A Closer Look at the MORryde Flip Tread RV Steps on a 2025 Brinkley Model Z Fifth Wheel
- Q&A: LCI Road Armor Wet Bolt and Bushing Kit
- Shop: DeeMaxx Trailer Wheel Lug Nut - Stainless Steel - 1/2" - Qty 1
- Shop: DeeMaxx Trailer Wheel Lug Nut - Chrome - 9/16" - Qty 1
- Q&A: Will I Have Turning Clearance Issues Using The Gen-Y Gooseneck Pin Box On Short Bed Silverado 2500?
- Q&A: Using SnapPad Jack Pads On An Andersen Block
- Q&A: Shock Kit And Gooseneck Pin Box For 2024 Brinkley Z3110 5th Wheel
- Shop: Suspension Enhancement
- Video: Review of Power Mountain Automotive Tools - Jacks and Jack Stands - PM34FR
- Q&A: Replacement Bronze Bushings for MoRryde CRE3000 Suspension System
- Video: Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers Review
- Video: What to Know About the 6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles
- Video: An In-Depth Look at the MORryde X-Factor Crossmember for Standard Frame Hangers
- Q&A: Can 50 Amp Power Watchdog Surge Protector be Used with 30 Amp Power Source
- Shop: RV Covers



Mike
5/27/2025
Wouldn't most of the grease get pushed out when greasing the wet bolt eliminating having to remove and disassemble the wet bolt? Then grease again in a short time.