Replacement Spring Bar Support Bracket for Curt TruTrack Weight Distribution System

Question

Question:

Concerning item number C17501, can I buy just one bracket assembly? If so, how much?

asked by: Ronald S

0

Expert Reply:

The spring bar support brackets on the Curt TruTrack Weight Distribution System # C17501 only come in a kit so you need part # C17508 which has both sides. Current pricing can be found directly on the product page.

expert reply by: Jon G

0

Answer 1

You are correct. You will only need the 14,000LB 2-5/16" Hitch Ball #EQ91-00-6140, Head #EQ90-02-1400 and Spring Bars #EQ90-01-1499 to convert your 10,000LB Hitch #EQ37100ET to a 14,000LB Hitch #EQ37140ET. The Sway Brackets #EQ95-01-5600 are…

view full answer...

Answer 2

I have some good news to offset some of that anger from recently being scammed. We do indeed have all of the replacement parts available for the Curt TruTrack Weight Distribution System #C17500 and I will list them out below. Replacement L-Pins and…

view full answer...

Answer 3

Based on your photo, the system was not setup correctly so the bars that should be applying friction to the brackets evenly is only hitting on that inside edge of the bar. That will not carry the weight correctly and definitely can cause scary sway.…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...