Replacement Circuit Board For MaxxAir Roof Vent Model Number 4951KS

Question

Question:

Looking for a circuit board replacement for a Maxair model MaxAir Smoke 4951KS - 0862. The board label is 10A04751KSZ 2019.12

asked by: Johnny H

0

Expert Reply:

The Replacement Printed Circuit Board # MA10A04751KS is the correct part for your MaxxAir 4951KS roof vent.

expert reply by: Bud M

0

Answer 1

You can use the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents #MA10A04751KS to replace your damaged 10A04751ksz MaxxAir circuit board. This is a direct replacement.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 4

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 7

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 8

Hi JD; the Furrion Chill Cube #FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system. Assuming you have a ducted system you will need…

view full answer...

Answer 9

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 10

Hi Zach, Yes, you can swap out your Dometic rooftop condenser unit with the Advent Air #ACM150. You'll just need to remove the cover to your air distribution box so that you can get to the mounting bolts and wiring. You'll want to find the…

view full answer...

Answer 11

The perfect solution for you is the Advent Air RV Air Conditioner w/ Air Distribution Box, Start Capacitor, and Heat Strip - 15,000 Btu #ACM150BCH. The white air distribution box installs on the inside (it doesn't come in black) so nobody will…

view full answer...

Answer 12

Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…

view full answer...

Replacement Circuit Board For MaxxAir Roof Vent Model Number 4951KS

Product Page this Question was Asked From

Continue Researching