How To Wire In The Monitor Light For The Roadmaster InvisiBrake Supplemental Braking System
Published 08/23/2023
Question:
The How is the ground accomplished between motorhome and towed vehicle for invisibrake monitor/alarm warning light located in the motor home?
asked by: Conrad S
Expert Reply:
The monitor light for the Roadmaster InvisiBrake Supplemental Braking System # RM-8700 would need to be grounded to the chassis of the motorhome. The LED light and audio signal will both have a wire to run down to the chassis and another wire to run over to the towed vehicle to connect to the cold side of the brake light switch. To accomplish this you'll most likely need to extend to wire to run it down to the chassis and then use a ring terminal and self tapping screw to connect the wires to the chassis.
(click to enlarge)
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Flat Tow Brake System
- Brake Systems
- Pre-Set System
- One-Time Setup
- Vehicle Battery
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Indicator Lights
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Roadmaster InvisiBrake Flat Tow Brake System Install Guide - 2025 Ford Maverick
- Shop: Sikaflex 715 RV Roof Sealant - Semi Self-Leveling - White - 300 ml
- Search Results: trailer brake controller
- Search Results: vehicle tow bar brake system
- Shop: Vehicle Tow Bar Brake System
- Search Results: rm8700
- Search Results: invisabrake
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Video: How to Install the Roadmaster Direct-Connect Base Plate - 2026 Ford Maverick
- Video: Easily Install Your Roadmaster Battery Charge Line - 2026 Ford Maverick
- Shop: Vehicle Tow Bar Wiring
- Shop: Base Plate for Tow Bar
- Search Results: freeze sensor
- Video: How to Install the Roadmaster 4-Diode Universal Wiring Kit - 2025 Ford Maverick
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Shop: Valterra Foam Weather Stripping for RV Air Conditioners - 14" x 14" Opening - 4-Piece
- Shop: Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Shop: Trailer Hitch
- Video: Checking Out the Roadmaster InvisiBrake Flat Tow Brake System
- Q&A: How To Install The Monitor Wire For The Roadmaster Invisibrake Supplemental Braking System
- Q&A: Braking Monitor/Alarm Kit Not Working When Installed On New RV Motorhome
- Q&A: How Long Should the Installation of the Roadmaster InvisiBrake # RM-8700 Take
- Q&A: Does Roadmaster InvisiBrake Require Trailer Brake Controller to Install
- Q&A: How Does Monitor of Roadmaster InivisiBrake Wire Up
- Video: Set up: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit on a 2019 Jeep Wrangler
- Video: DIY Install: Blue Ox Patriot Portable Flat Tow Brake System on your 2018 Jeep JK Wrangler
- Shop: Trailer Wiring
- Shop: Prime Guard Glycerin Free RV & Marine Antifreeze -50°F Burst Protection - 1 Gal - 6 Jugs
- Search Results: invisibrake 8700