Solution for Needing Replacement Kwikee Linkage 151364

Question

Question:

i need a kwikee step gear linkage only 151364. Do you have this?

asked by: Steve D

0

Expert Reply:

We aren't able to get that part number any more but it used to be 379649. Only solution would be a new gear box and A linkage part # LC379160.

expert reply by: Jameson C

0

Answer 1

We've checked with Kwikee in the past for the linkage arm 151364 and the correct replacement is the part #LC379649. For the entire gear box and linkage the correct part number is the #LC379160 that you mentioned.

view full answer...

Answer 2

I have a solution for you, but the Kwikee part number 909506000 has been discontinued by the manufacturer, which is why you're not seeing it. Also, the #LC379146 and #LC301702 would not be the correct parts, since they're for newer Kwikee…

view full answer...

Answer 3

Hey Jack, are you sure you need exactly 3 inch outer diameter from the center cap? We have close to that on the smaller and bigger side but not exactly 4 inches.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Solution for Needing Replacement Kwikee Linkage 151364

Product Page this Question was Asked From

Continue Researching