What Size Wire Should Be Used With the Go Power Solar Entry Cable Plate?

Question

Question:

What is the largest gauge wire I can feed through this?

asked by: Herb H

0

Expert Reply:

I wouldn't go larger than 10 AWG with the Go Power Solar Cable Entry Plate for MC4 Cables # 34273840. The larger wire will just make sure that you are getting enough power to your entry plate from the solar panel.

I recommend going with an option that already has the power wires hooked up like # 34276245 for 7', # 34273841REVA for 10', or # 34273843REVA for 25'.

expert reply by: Bryce D

0

Answer 1

In order to use the Prodigy RF #TK94FR you will need to install a 7-Way trailer connector on your 2014 Ford Escape. For that you will need #37185, a 40 amp circuit breaker, #PK54540, and enough 12 gauge wire, #12-1-1, to reach from the back of the…

view full answer...

Answer 2

You could use larger MC4 cable gauge wire from the Go Power Solar Cable Entry Plate #34273840 to your controller but it wouldn't benefit you very much unless you used larger gauge wire from the solar panel to the entry plate. Larger gauge wire…

view full answer...

Answer 3

To install a 7-Way trailer connector on your 2012 Ford Escape you will first need to install a 4-Way using #118551 (since there isn't a plug and play 7-Way options for your 2012 Ford Escape). Then you can install #37185. Since you will be using…

view full answer...

Answer 4

The Prodigy RF brake controller #TK94FR requires 12 volt power and the brake light signals to function in the 7-Way in order to work. On the 7-Way you have there should be a black wire which will be for 12 volt power. Using about 25 feet of wire…

view full answer...

Answer 5

First contact your RV manufacturer and see if they can provide you a schematic of your roof trusses and wiring areas to avoid. If they cannot provide you this information I would check some user forums for your brand and see if others can identify…

view full answer...

Answer 6

We do have a pre-wired entry plate with MC4 connectors with the Go Power Solar Cable Entry Plate with Red and Black MC4 Cables #34273841REVA. The shorter wires that come with it are 10 gauge but for long runs of 8 gauge like you mentioned this would…

view full answer...

Answer 7

The correct version is the one seen towards the top of the Go Power Solar Cable Entry Plate #34273841REVA page. Not the larger one at the bottom. Go Power recently changed the style to a smaller footprint with better injection molds. I have included…

view full answer...

Answer 8

The female side of the MB Sturgis Propane hose part #100304-60-MBS is a size 3/8" female flare. 3/8 NPT fittings like this have 18 threads per inch.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

What Size Wire Should Be Used With the Go Power Solar Entry Cable Plate?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching