How To Get Both A 7-Way And 4-Pin Connector On A 2011 Nissan Frontier

Updated 07/07/2023 | Published 07/06/2023

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(472)

$55.83

Question:

I have a 2011 Nissan frontier I installed my self a factory 4 pin connector it plugged in back of truck behind bumper and then put the jumpers in under passenger front side kick plate Will I be able to disconnect the 4 pin harness and plug in this harness so that both 7 pin and 4 pin work I plan on pulling a trailer with trailer brakes thats why I need the 7 pin will i need any other jumpers so the pin assembly works

asked by: Jeff F

Expert Reply:

You are definitely on the right track. It sounds like you did install a wiring harness and relays like part # C56225. If those relays have been installed all you would need is the part # HM43534 that you referenced. This will plug right in and give you both a 7-way and 4- pin connector.

For operating electric brakes you will also need a brake controller. I recommend the Tekonsha prodigy P3 part # 90195. This is a great all around controller and gives you pully proportional braking. Large accessible buttons and a Customizable, easy-to-read LCD display make this one of the best controllers on the market. You also have the option of a plug-and-play pigtail # 3050-P also, so install will be a piece of cake.

I have included links to a few videos below for you to take a look at.

expert reply by: Jesse M