Can Malone Hitch Extender MAL32VR Angle Back Like Rhino Rack T-Load

Question

Question:

Can this be angled like the Rhino Racks T-Loader for rooftopping larger kayaks? Im looking to potentially rooftop carry a 13foot 36inch wide Crescent Crew on a Silverado 1500 with RSI SmartFTP topper and bars.

asked by: Kelly

0

Expert Reply:

The Malone Load Extender part # MAL32VR that you referenced does not have ability to angle back like the Rhino Rack T-Load part # RTL002 has so your best option would be to go with the Rhino Rack.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 5

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 6

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hi Ken! It looks like you have almost everything you need to set up your 2026 Jeep Gladiator Sahara for flat towing. The etrailer Invisible Base Plate Kit - Removable Arms #e98948 is a perfect fit and the etrailer XHD Non-Binding Tow Bar - RV Mount -…

view full answer...

Can Malone Hitch Extender MAL32VR Angle Back Like Rhino Rack T-Load

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching