Replacement Brake Kit and Boot for Power Gear Motor 1010001093

Question

Question:

Im looking for 2 power gear Brake Service Kit #1010001289 and 2 Boot Replacement Kit #1010001232. The power gear motor is p/n 1010001093 and s/n 0710624898.

asked by: Eric

0

Expert Reply:

Yes, we do offer both the Electric Jack Brake Replacement Kit part # LC87VF and the Electric Jack Motor Boot part # LC47VF. I got these added to our system for you.

expert reply by: Conner L

0

Answer 1

We do have the motor boot change service kit you are looking for: - Replacement Motor and Wiring Harness for Lippert Power Gear Electric RV Leveling Jacks #LC47VF

view full answer...

Answer 2

The correct replacement gear motor that replaces the Power Gear 1510000006 on your 2006 Fleetwood Fista is the Replacement PowerGear RV Above Floor Slide-Out Motor #LC368417. The Replacement Gear Motor #LC368193 you were looking at will not work…

view full answer...

Answer 3

Hello Alicia, thanks for reaching out. I was able to cross reference the part number 140-1226. The correct replacement touch pad for this is the following: - Replacement Control Touch Pad for Power Gear RV Auto Leveling System #LC44UJ

view full answer...

Answer 4

The correct replacement part is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right, part #LC89CJ, if your are replacing the right motor. I have included a product description link and video demo link below. .

view full answer...

Answer 5

The only solution I have is for a complete replacement system. Unfortunately, the Atwood Leveleg system was discontinued so there is not a replacement jack available. For a replacement, I recommend the Lippert Ground Control 3.0 Electric 5th Wheel RV…

view full answer...

Answer 6

The correct replacement for your 524120 slide out motor is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC27VR. I confirmed this with my contact at Lippert.

view full answer...

Answer 7

The replacement motor that you are needing is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right #LC89CJ (Lippert part number 386211) the 386211 is the correct replacement for the 1010001019 (right side). We also have…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Brake Kit and Boot for Power Gear Motor 1010001093

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching