Recommended 2,000 Lb Trailer Axle with Brakes for Small Trailer
Published 12/20/2022
Products Featured in This Question
Question:
Can you add springs, hardware and hangers appropriate to this axle rating so that I can order everything from the trailer frame down minus the wheels. Thanks.
asked by: M. D
Helpful Expert Reply:
The best option we could provide you with is the Trailer Idler Axle Beam part # e48GR which measures 60" long and has a 2,000 lb weight capacity. It's not setup for brakes so in order to equip them you'd need to have a brake mounting flange welded on, the Brake Mounting Flange for 1-3/4" Round Trailer Axles part # 4-34. This will then allow you to add brakes like the Electric Trailer Brake Kit part # AKEBRK-2 and hubs/drums like the Easy Grease Trailer Hub and Drum Assembly for 2K Axles part # AKHD-545-2-EZ-2K.
Unfortunately, we don't have any parking brake options for this size axle.
Product Page this Question was Asked From
Trailer Idler Axle Beam with Easy Grease Spindles - 60" Long - 2,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 2000 lbs
- Spindles Only
- 48 Inch Spring Center
- 60 Inch Hub Face
- No Drop or Lift
- etrailer
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Search Results: 4 way to 7 way
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Adding Electric Brakes To 2,200lb Dexter Torsion Axles
- Shop: Brake Mounting Flange for 1-3/4" Round Trailer Axles - 2K
- Shop: Easy Grease Trailer Hub and Drum Assembly for 2K Axles - 7" - 5 on 4-1/2 - L44643 - Pre-Greased
- Shop: Easy Grease Trailer Hub and Drum Assembly for 2K Axles - 7" - 5 on 4-1/2 - L44649 - Pre-Greased
- Shop: Dexter Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs to 2,200 lbs
- Shop: Electric Trailer Brake Assembly - 7" - Left Hand - 2,000 lbs
- Shop: etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Q&A: Should I Put Brakes on the Front or Back Axle of my Tandem Axle Trailer
- Q&A: Placement of Front and Rear Hangers When Building a Tandem Axle Trailer
- Q&A: Should I Use Leaf Spring Spacers Lift Blocks on a Trailer to Raise It
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Search Results: wire
- Video: Installing the Curt Powered Tail Light Converter Trailer Connector on a 2025 Kia Sportage
- Q&A: Can Inline Fuse be Used to Run 12 Volt Hot Lead to 7-Way
- Search Results: circuit breaker
- Q&A: What Gauge Wire To Use For Power Wire On 7-Way?
M. D.
12/20/2022
Can you add springs, hardware and hangers appropriate to this axle rating so that I can order everything from the trailer frame down minus the wheels. Thanks.