Replacement Towers for Malone Square Bar Roof Rack # MPG201

Question

Question:

I have a pair of Malone roof crossbars. The rubber tips on the clamps have deteriorated, and I’d like to replace them. The last time I used the crossbars they scratched the rails on the car.

asked by: Grant D

0

Answer 1

The Malone Universal Crossbar System #MPG201 is a more economical choice but it still does a good job. The design and quality of Thule's system is why they have such a large difference in price. Whether you go with the Thule Crossroads system…

view full answer...

Answer 2

Yes, it will! The Thule Motion XT Rooftop Cargo Box item #TH629806 will have no issue mounting to square crossbars like the Malone item #MPG201. The only concern would be the rear hatch opening. You need to have the front crossbar 51-1/4" from…

view full answer...

Answer 3

Roof racks can add some wind noise. Luckily there is a solution for that. If you install a wind fairing you'll direct the air over the bars and the noise will go away. For a fairing to use with the Malone roof rack part #MPG201 the part #INA261…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 7

Hey Jason, whenever available I would recommend going with the channel attachment for roof rack accessories including the Thule Hullavator part #TH898 as its simpler stronger, and it's basically the future of most roof rack accessories as it…

view full answer...

Answer 8

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Answer 9

You will need a different converter charger if you are going to lithium batteries, which is what I believe you are asking. The right one will depend on how many amp hours you need though, like the 100 amp-hour #34282738. I have added a link below to…

view full answer...

Answer 10

Hi Ric; using a converter that is not rated for lithium is not recommended. Your existing WFCO converter won't be able to fully charger a battery like #34282738, it could overheat, and might trip the BMS which would shut the battery down until it…

view full answer...

Answer 11

Hi Scott, thanks for reaching out. A great replacement for the 3,500-lb Lippert jack on your Jayco 32BHDS is the etrailer Electric Trailer Jack – A-Frame – 18" Lift – 3,500 lbs #e23ZV. It’s a bolt-on swap with the same capacity, upgraded…

view full answer...

Answer 12

I have a complete replacement jack option for you, but the buttons on your Lippert Smart Jack #LC643589 are not replaceable so the only option is a complete replacement. If your jack is still within the 1-year warranty period then I recommend…

view full answer...

Replacement Towers for Malone Square Bar Roof Rack # MPG201

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching