Log Splitter Hub for Spindle Dimensions of 1 inch Bearing and 1.25 inch Grease Seal
Updated 11/14/2022 | Published 11/13/2022
Products Featured in This Question
Question:
Good morning, Im looking for hubs to put on a log splitter. The spindles are 1 dia. 3 3/8 from bearing shoulder to threaded end. The inner seal area diameter is 1 1/4. Thanks
asked by: Jeff S
0
Expert Reply:
Thanks for the spindle dimensions of your log splitter. Based on that the correct hub you'd need is the part # AKIHUB-440-2-G-1K which matches this and has a 4 on 4 inch wheel bolt pattern. If instead you need a 5 on 4-1/2 inch bolt pattern you'd want the part # 34822545BX.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L44643 / L44643
- Marine Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Looking for Hub for 1999 Jayco Qwest 10
- Q&A: Should There Be a Washer Between Outer Bearing and Castle Nut on etrailer 2,000 lb Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: 4.80R12 Tire Mounted On Wheel
- Q&A: Does Ducted Furrion Chill Cube With Heat Pump Include Remote
- Q&A: What Leaf Spring Should Be Used With 2,000 lb Axle?
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: Trailer Couplers
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings