Timbren Axle-Less Suspension For A 2018 Starcraft Satellite 18MK
Updated 09/26/2022 | Published 09/25/2022
Products Featured in This Question
Question:
Bought a 2018 Starcraft Satellite 18MK a year ago and I have taken 3 trips and gone through 2 dexter axles being bent. After much research and emails to Dexter and Starcraft I found it has an 89inch axle with a 58inch spring center when it needs a 74inch spring center but the design of the frame will not accommodate more than 58. Starcraft will not help because I am not original owner and Dexter will not help because the spring center mounting is wrong. In doing my research I came across the Timbren Axle-Less Trailer Suspension System and was wondering if this Suspension system would be good to replace what I have? Looking forward to hearing from you.
asked by: Diana P
Helpful Expert Reply:
With your axles bending constantly and not having the correct spring center mounting, The Timbren Axle-Less Suspension # ASR5200S01 would be a great replacement for your 2018 Starcraft Satellite 18MK.
Using the system mentioned above it gives you two independent units that can eliminate the need for a thru axle. Doing this will increase your ground clearance and will fit any trailer width. The Timbrens are easy to install and align. They can either be bolted on or welded onto your trailer's frame.
The system will fit hubs with an Inner Bearing # 25580 and an Outer Bearing # 14125A. So The Easy Grease Trailer Hub and Drum for 5.2K to 7K Axles - 12" - 8 on 6-1/2 - Galvanized # AKHD-865-7-G-EZ-K will be the correct kit that will work with the Timbrens. The brake flange of the Timbren system is a 5 bolt so The Dexter Electric Trailer Brake Kit # 23-180-181 is the correct brake system needed.
I attached a review video link below.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 5200 lbs
- Spindles Only
- 71-1/2 Inch Spring Center
- 86-1/2 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Axle Beam for 2020 Grand Design Reflection 315RLTS
- Q&A: Replacement For 86-1/2 Inch Long 5,200 lb Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Brake Shoes/Pads for the Dexter 023-341-01 and 023-340-01 Hydraulic Brake Assemblies
- Q&A: How to Determine Spring-Center and Hub-Face Measurements when Building a Trailer
- Q&A: How to Determine Where to Drill the 4 inch Hole to Install B&W Gooseneck Hitch # BWGNRK1257
- Q&A: How To Choose Correct 3,500 Lb Axle for Slipper Spring Setup
- Q&A: What is the Minimum Space Between Tires on a Tandem Axle Trailer
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller Installation: Starting from Scratch
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub