Replacement Handle For The Roadmaster Sterling Tow Bar

Question

Question:

I have the roadmaster sterling tow bar with the threaded handles. Are these replacement handles available?

asked by: David C

0

Expert Reply:

The Replacement Handles for Roadmaster Sterling # RM-910003-35 per Roadmaster is the correct replacement part for you.

The overall length of the handle is 6-1/2 inches.

If you need any of the hardware for the handle you will need the Spring Kit # RM910652.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 2

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 3

If you can provide me with exactly what tow bar you have I may have better information for you but I had saw you were looking at parts for the older Roadmaster Sterling Tow Bar so I will assume that is what you have. In order to free the arms…

view full answer...

Answer 4

Hey Tim, the correct rebuild kit for a Roadmaster Falcon All Terrain tow bar like you have is the part #RM910003-85. How many miles do you have on your tow bar you think?

view full answer...

Answer 5

The Replacement Handles for Roadmaster Sterling All Terrain Tow Bar #RM-910003-35 are held in place with pins. These should be reused from the original handles. I included a picture from the instructions for the Sterling tow bar #RM-576 that shows…

view full answer...

Answer 6

I will walk you through which parts you need starting from your 2009 Honda CR-V and move towards the vehicle. First you need base plates for the CR-V if you do not already have them. The base plates available for your CR-V are RoadMaster part…

view full answer...

Answer 7

What you would need is the part #RM910003-32 for the bolts, the part #RM-200029-10 for the bushing and then for the yoke part #RM910575 and you'd be set. There isn't an entire kit that covers all the parts you need but with these three part…

view full answer...

Answer 8

The Roadmaster #RM-910003-40 replacement bushing kit you'd mentioned is compatible with Roadmaster Sterling tow bars with serial numbers lower than 27671. Since the serial numbers on both your Sterling tow bars are lower than 27671, the…

view full answer...

Answer 9

Hi Ed; the replacement shank/stinger for your Roadmaster Sterling All Terrain Tow Bar is the #910019-40. If you need the yoke we also have that available #RM910575. It is also worth mentioning that Roadmaster recommends replacing tow bars at 8-10…

view full answer...

Replacement Handle For The Roadmaster Sterling Tow Bar

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching