Replacement Idler Hubs For A 7,000 Pound Axle With 9/16 Inch Studs  

The best way to remove a Bearing Buddy Bearing Protector like #BB2717 is pretty much what you've been doing. Because the fit inside the hub bore is pretty tight, you just have to take a rubber mallet (or wood block) and firmly tap it around…

I don't recommend upgrading one axle at a time. The capacity differences are substantial, and you will be limited to the weakest component. So the axle, the springs, the equalizer, the brake assemblies, and the hub/drum assemblies would all…

It is not recommended to use the Timbren Axle-Less Trailer Suspension System item #TASR7KS01 but it can be done. I spoke with my rep over at Timbren and they have done a triple axle set up but the reason they don't recommend it is because…

For your trailers, I recommend not using a steering axle because there are different requirements for them and your trailers don't need them. If you want to pursue the steering axle you will need to check with your local DMV for requirements. My…

It took a little while to get your information from Dexter. Your axle is a #13 Torflex Axle which is rated for a capacity of 8,000 lbs. We don't have an 8,000 lb capacity replacement, but we do have 7,000 lb capacity Axle-less Systems you may…

If just the spindle is bent, we have the #42 Spindle for 5,200-lb to 7,000-lb Trailer Axles - 2-1/4" Diameter #TRU57FR as a replacement. If you have more than a bent spindle then the other option is to replace your entire axle. Because you…

If you are changing the wheels from 8 inch to 12 inch and have a 4 on 4 bolt pattern, and If the wheel is stud-piloted, then the pilot hole hole does not matter. However, if the wheel is centered using the pilot hole, then you will need to find a…

Backspacing and offset are terms used to look at the same thing in a different way. Backspacing is described as the distance from the center of the hub to the inside edge of the wheel at the bead seat whereas offset is the distance from the center of…

Thanks for the picture of what you have and the info you listed. The correct wheel you need is the part #AM20794 that you referenced.

It is easy to tell which type of wheel you have on your boat trailer. Lug centric wheels slide onto studs on the hub and are secured with lug nuts, like a car tire. If a wheel is hub centric, the wheel centers on the hub and bolts are threaded into…

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a picture…

We do indeed have a hub that will let you use the Westlake 215/75R17.5 Radial Tire w 17-1/2" Lynx Aluminum Wheel - 8 on 6-1/2 - LR J - Black #LHAS701 on your trailer. The etrailer.com Easy Grease Trailer Hub and Drum Assembly #AKHD-865-7-1-EZ-K…