Replacement Damper For Ventline RV Range Hood
Published 05/13/2022
Question:
I lost the damper/flapper on the outside of our RV in transit. Measurements for the opening are 10 3/4 inches X 4 inches. I dont know the model of the vent itself. Could you recommend a replacement part. And if its too large, can they be trimmed to size?
asked by: Jeremy S
Expert Reply:
I took a look at what you're looking for, and the closest I was able to get to match the measurements you need is the:
-Replacement Damper for Ventline RV Range Hood w/ Horizontal Exhaust # BCA0472-00.
This damper has an overall length of 10-1/4", and a width of 4-3/8".
As far as trimming is concerned, it is not recommended or advised to modify this part, as it isn't designed to and may not work as intended.
Product Page this Question was Asked From
Replacement Damper for Ventline RV Range Hood w/ Horizontal Exhaust
- Accessories and Parts
- RV Range Hoods
- RV Vents and Fans
- Range Hood
- Damper
- Ventline
more information >
Continue Researching
- Q&A: Will Replacement Flange for B&B RV Endura Range Exhaust Vent Fit 2025 Grand Design Momentum 27MAV
- Q&A: Replacement Hubs for BD-545-17 Drum Brakes and Braking Assemblies
- Q&A: What Parts are Needed to Install Patio System on a Toy Hauler Door
- Q&A: Kit to Convert Toy Hauler Ramp Into Patio/Deck
- Q&A: Replacement Options For A Dometic RV Air Conditioner Model # 57915.541
- Q&A: Looking For Replacement Travel Trailer Exterior Exhaust Vent
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Article: How to Repair an RV Roof
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Replace or Install an RV Roof Vent
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV