Is there Any Drilling Required to Install the Malone Axis Load Roller # MAL52VR?
Published 04/19/2022
Products Featured in This Question
Question:
If I want to add the Malone Axis roller at a later date do holes have to be drilled in the end uprights to accommodate it?
asked by: Dave A
0
Expert Reply:
No, there is no drilling required to install any component of the Malone Axis Truck Bed and Roof Load Extender with Load Roller - 2" Hitches # MAL32VR or just the Malone Axis Load Roller for Malone Truck Bed and Roof Load Extender - 42" Long # MAL52VR.
I went ahead and attached a video that shows the pre-drilled holes on the uprights to install the rollers at timestamp 13:30.
expert reply by:
Bob C
0
Product Page this Question was Asked From
Malone Axis Truck Bed and Roof Load Extender with Load Roller - 2" Hitches - 375 lbs
- Truck Bed Extender
- Adjustable Height
- Adjustable Width
- 28 - 48 Inch Wide
- Hitch Load Extender
- Steel
- Black
- Malone
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Load Assist for Loading Canoe On Malone TradeSport Truck Bed Ladder Rack
- Q&A: Diameter and Weight Capacity of Malone Truck Bed Extender Roller # MAL52VR
- Q&A: Comparing Yakima LongArm Truck Bed Extender and Bed and Roof Load Extender
- Article: Anti-Rattle Devices
- Q&A: SumoSprings Kit Recommendation for 2025 Chevy Silverado 1500 Towing Camper
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Can 2019 Ford Ranger Tailgate be Lowered with Yakima LongArm Extender Installed
- Q&A: Truck Bed Extender With Load bar Wider Than 38 Inches
- Article: Best Bike Racks for Electric Bikes
- Article: Best Running Boards
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Tire Sizing