Replacement Gears For A Bulldog Trailer Jack
Updated 04/19/2022 | Published 04/18/2022
Question:
the label on the jack is #01576, the gears measure 11/8inch in dia and have a hole in the center of 1/2inch and the gears have 12 teeth on both. do you have these gears on hand?
asked by: Donald L
0
Expert Reply:
For your Bulldog Jack, it sounds like you're looking for the Replacement Sidewind Handle and Gear Kit for Bulldog Round Jack # BD500256.
This kit includes two gears that have a 1-1/8" outer diameter, 1/2" inner diameter, and have 12 teeth. As well as a crank assembly and a 5.8" long handle.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Replacement Sidewind Handle and Gear Kit for Bulldog Round Jacks - 2,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Sidewind Gear Kit for a Bulldog 190754 Jack
- Q&A: Replacement Handle Recommendation for Bulldog Sidewind Trailer Jack # BD180455
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Bearing Kit & Seal For Dexter 031-030-02, 031-032-02 Bearings
- Q&A: Replacing Trailer Buddy 32220 Reverse Solenoid on Ranger Boat Trailer
- Q&A: Pin Hole to End of Shaft Dimension for the Bulldog Replacement Jack Handle Part # BD500105
- Q&A: Does The Insta Holding Tank Patch Kit # SR48RR Adhere To Polyethylene
- Q&A: Determining Correct Grease Seal and Axle Capacity on Vintage Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Best Boat Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)