Do the Fulton Plastic Trailer Fenders Come with Mounting Brackets
Updated 09/06/2013 | Published 09/05/2013
Products Featured in This Question
Question:
Replacing metal fenders on shore lander trailer with 13 inch wheels. Brackets welded to fenders. Do you have brackets to mount new plastic fenders?
asked by: Billy L
Expert Reply:
For the Fulton trailer fenders like # F008574 you would need to use your own mounting brackets/hardware because there is no one set way to mount the fenders. You may be able to just modify your existing brackets. These fenders have a cutout in the back, see picture, on each side to allow for brackets.
Or you may be able to use mounting brackets # PF1135-BKT-2.
Product Page this Question was Asked From
Fulton Single Axle Trailer Fender with Top and Side Steps - White Plastic - 14" Wheels - Qty 1
- Trailer Fenders
- Top and Side Step
- 14 Inch Wheels
- 9 Inch Wide
- 42-5/8 Inch Long
- Plastic
- Bolt-On
- For Single-Axle Trailers
- White
- Fulton
more information >
Continue Researching
- Q&A: Looking For Caliper To Replace Discontinued Tie Down Engineering 46802 Caliper
- Q&A: What Air Pressure Should I Run in My Trailer Tires?
- Q&A: How to Determine the Right Air Pressure to Fill a Trailer Tire
- Q&A: Do You Have an Aluminum Fender 11" Wide for a 15" Wheel on My Mission Enclosed Trailer?
- Q&A: Plastic Fender Recommendation for Shorelander Trailer with 14 inch Wheels
- Q&A: Dimension of Mounting Hole on Redline Trailer Fender # PF11X35W
- Q&A: Recommended Trailer Fender and Lights for Boat Trailer with 13" Wheels
- Article: Trailer Maintenance Schedule
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Where to Position the Trailer Axle?
- Article: Trailer Tire Sizing