Running Boards and Rear Hitch Step for 2015 Mercedes Sprinter

Question

Question:

can you suggest side steps and a rear hitch step for my 2015 Spinter? thanks!!

asked by: MARIA H

0

Expert Reply:

For your 2015 Mercedes Sprinter we have the Aries Running Boards part # AA86ZB as a confirmed fit that would work well. Then for a wider rear step that was designed to fit a hitch we have the Westin HDX Drop Hitch Step part # W98TD.

expert reply by: Jameson C

0

Answer 1

I may have a solution for you, however the Bestop TrekStep Side Mounted Truck Step #B7540315 referenced in your question will not work for your 2017 Ford F-250. There is not a custom truck bed step currently available that will fit your truck. I…

view full answer...

Answer 2

Technically, you could leave the hitch stair steps, #RHS2, mounted in the hitch while you drive. But it is going to affect ground clearance since the lower step is several inches below the receiver. I advise also adding an anti-rattle device such as…

view full answer...

Answer 3

You do not have to remove the tailgate on your 1997 Ford F-150 to use the Brophy Hitch Stair, #RHS2. If you keep the tailgate down you will not be able to use the top step because it will be covered by the tailgate, but you can still use the lower…

view full answer...

Answer 4

While the total extension that the Hitch Extender for Brophy Hitch-Mounted Stairs #RHSE provides is 19-1/2 inches from the closest pin holes it is not designed for use as a standard type of hitch extension. This should only be used with the hitch…

view full answer...

Answer 5

I have attached for you some dimensions of the Hitch Stair with 2 Steps for 2" Trailer Hitches part #RHS2 that you can then use to determine if it will work on your 2014 GMC Sierra 1500 in the fashion that you described. That said, the step can…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

Hey Jerry, GM moved the placement of their puck systems starting with 2020 models so you are correct that the pucks would have the hitch not sit directly over the axle. GM did the math and made sure that this placement wouldn't adversely affect…

view full answer...

Answer 8

Hey Christian, Yes, the TorkLift Tie Downs - Custom Frame Mount - Front and Rear #TL29DR will fit your 2016 Ram 2500 Crew Cab with running boards as long as you have a factory hitch receiver or no receiver at all. If your 2016 Ram 2500 Crew Cab with…

view full answer...

Running Boards and Rear Hitch Step for 2015 Mercedes Sprinter

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching