Can The Fulton Single Axle Trailer Fenders Be Mounted By The Inner Fender?  

The Fulton Single Axle Trailer Fender with Top Step - White Plastic - 12" Wheels - Qty 1 #F008542 mounts using brackets like the Mounting Brackets for Trailer Fender - 8"/12" Wheels - Galvanized Steel - Qty 2 #CE26061G-2. I've…

The Fulton Single Axle Trailer Fender #F008559 referenced in your question is designed for use with 8 to 12 inch diameter wheels. If this is what you have, then the Fulton Fender should work as a replacement, however you may need to fabricate your…

I do have an option for you but the closest sized fender we have for what you're looking for is the Fulton Single Axle Trailer Fender with Top Step part #F008542 which measures 23-11/16" long x 7-1/2" wide x 8-11/16" tall. This is…

Yes you need to use brackets like part #CE26065PGA or #CE26061G to install the Fulton Single Axle Trailer Fender with Top Step #F008542. Basically you just secure one side of the bracket to your trailer and then the other side of the bracket to the…

We recommend having about 4" of clearance height-wise to account for suspension movement and at least 2" width-wise between your tire and trailer fender or trailer frame like part #HP66VR that was referenced. Since you are building a…

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…