Mounting Single Axle Fenders With Trailer Fender Mounting Brackets  

We recommend having about 4" of clearance height-wise to account for suspension movement and at least 2" width-wise between your tire and trailer fender or trailer frame like part #HP66VR that was referenced. Since you are building…

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

The minimum distance between the inside of a tire and the frame rail depends a lot on the setup of the trailer. But as long as the tire and the frame don't touch you would be fine. It's hard to give an exact figure as trailer setups…

I recommend using the Fulton Single Axle Trailer Fender #F008542 if you are wanting to mount the fender on the inner wheel flange. The Fulton Single Axle Trailer Fender #F008540 uses Mounting Brackets #CE26065PGA to hold the fender in place. It…

Yes you need to use brackets like part #CE26065PGA or #CE26061G to install the Fulton Single Axle Trailer Fender with Top Step #F008542. Basically you just secure one side of the bracket to your trailer and then the other side of the bracket to the…

I do have an option for you but the closest sized fender we have for what you're looking for is the Fulton Single Axle Trailer Fender with Top Step part #F008542 which measures 23-11/16" long x 7-1/2" wide x…

The Fulton Single Axle Trailer Fender #F008559 referenced in your question is designed for use with 8 to 12 inch diameter wheels. If this is what you have, then the Fulton Fender should work as a replacement, however you may need to fabricate your…

The CE Smith Single Axle Trailer Fender part #CE17100ATB that you referenced has a radiused lip on both sides of the fender. It can still be bolted on though as the fender lip does go flat. It will set flush to the side of your trailer, but the…

You can definitely install the galvanized steel e-track on your trailer that has a galvanized steel floor, as really the only potential issues are when installing e-track on dissimilar metals. So you can absolutely install any of the following…

When installing the etrailer Horizontal E-Track part #e65VR we generally use a rubber material that is generally used as a liner in garden ponds as an isolator for the two dissimilar metals. It is easy to cut into strips and place under the full…

We do offer two very similar black plastic fenders from Fulton, both also with a top step, part #F008559 and #F008551 that can be seen on the link provided. The white Fulton Single Axle Trailer Fender with Top Step #F008542 measures 7-1/2 wide x…

First, I would prime and paint the whole bracket if for nothing else but to make sure it is all uniform. Galvanized steel is going to require certain products to be able to paint it and have the paint last. the first thing you will need to do is…