Will the HydraStar Electric Over Hydraulic Actuator HS481-8067 Work with F-150 Controller

Question

Question:

2018 Ford Raptor OEM brake controller work with HS481-8067 and boat trailer has disk brakes, max 7000 lbs.

asked by: Charles

0

Expert Reply:

The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes part # HS481-8067 has the factory brake controller adapter included so it will work with any integrated factory trailer brake controller like a 2018 Ford F-150 Raptor.

expert reply by: Conner L

0

Answer 1

Similar to the Hydrastar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes #HS481-8067, what you'll need for your RAM with an OEM brake controller is the: -Hydrastar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV…

view full answer...

Answer 2

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 3

The correct kit to upgrade your brakes is the HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes - OEM - 1,600 psi #HS481-8067. This kit comes with the actuator, wiring harness, and breakaway that you will need in order to…

view full answer...

Answer 4

We do sell the caliper but it will come with pads included. I have three options for you listed below depending on your trailer's application: Kodiak Disc Brake Caliper - Dacromet - 3,500lbs to 6,000lbs #KDBC225DAC. - Dacromet plating provides…

view full answer...

Answer 5

I was able to go out to the warehouse and measure the clamp-on mounting bracket for HydraStar EOH Actuators #HS304-7169. I made you a dimensional diagram to better see, but found that the mounting holes for the u-bolt are 13-1/8 inches by 3-5/8…

view full answer...

Answer 6

The Hydrastar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes #HS481-8067 is designed to be completely plug-and-play so the female end of the 7-way would need to connect to the 7-way cable that's already installed on the trailer…

view full answer...

Answer 7

You will need to use electric over hydraulic brakes to back down a boat ramp and still have the brakes apply. A Surge Actuator #DM72VR will not apply the brakes since the weight of the trailer is pulling the trailer back down the hill versus pushing…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Morgan, the best hitch for what you are looking for would be the Draw Tite part #DT73RR which has the easiest install and the highest tongue weight rating. The hitch does fit right up under the rear bumper which will slightly reduce ground…

view full answer...

Answer 10

Hey Matt, I would highly recommend the Hydrastar Marine electric over hydraulic actuator part #HS481-8067 for your boat trailer. We have found that the Hydrastar actuators are the most reliable and best performing so it's always what I recommend.…

view full answer...

Answer 11

Hey Nick congrats on the new car! The bottom portion of the receiver for the Curt item #C69VV sits 11-3/4" above the ground when installed on your 2025 Subaru Outback Premium. If you're worried about ground clearance, I recommend installing…

view full answer...

Answer 12

Hi Jessey! We have everything you need for your 2024 Subaru Outback. To start, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C67JR. This is a little bit of work to get installed, but it is going to be the best…

view full answer...

Will the HydraStar Electric Over Hydraulic Actuator HS481-8067 Work with F-150 Controller

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching