Wiring Diagram For The Jensen RV Stereo System # JWM60A

Question

Question:

on my radio the yellow connects to the 12vdc battery power, the red connects to the 12vdc switch power and blue connects to the 12vdc trigger. What corresponding wires on the jwm60a would these wires connect to?

asked by: BENNY K

0

Expert Reply:

I've attached the wiring diagram for the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth, jControl - 12V # JWM60A (pictured below) which will show to the function of each wire color in the wiring harness to aid you during the installation process.

expert reply by: Kevin C

0

JWM60A Wiring Diagram
(click to enlarge)

Answer 1

There is a way for you to determine the correct replacement landing gear for your 2010 Keystone Fuzion, though we do not have landing gear made specifically for your trailer. Instead, you will need to measure the mounting brackets on your trailer…

view full answer...

Answer 2

I did a little research and if you have OEM mirrors like the smaller mirror pictured, the Dual-View Clip-On Towing Mirror, #11953 will work. If the mirrors installed on your 2004 F-250 are the taller mirrors like those seen in the picture provided,…

view full answer...

Answer 3

I recommend to replace the Furrion DV1200 with the Jensen RV Stereo part #JWM60A. The Jensen brand is very reliable and fits almost the exact cut out of the Furrion DV1200 according to it's manual. You will only need to expand the cut out by a…

view full answer...

Answer 4

We do have other replacement options but manufacturers make their wiring harnesses different so you would have to resplice together your wiring to a new harness unless you used the same model stereo. To keep the same features you have with the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Wiring Diagram For The Jensen RV Stereo System # JWM60A

Featured Help Information

Miscellaneous Media

Continue Researching