bing tracking image
Q & A Icon

Replacement Oil Bath Hub and Drum Assembly for 8K Dexter Axle

Question:

Have a Dexter 8,000 pound OIL bath Axle. Looking for components. Spindle is damaged, can the spindle be replaced, bolt on or weld on? Do you have to replace axle shaft? Looking for all new parts on driver side left side. Hub/drum kit with bearing components and brake kit the bolts on. Thank You,

0

Expert Reply:

If just the spindle is damaged then you could probably get away with just replacing the spindle, but if the axle is damaged then you'll to replace the whole axle. If you aren't sure how much is damaged then you might want to have a shop look at your trailer just to make sure you have a safe setup.

We do have replacement hub/drum assemblies that use the oil bath setup but for spindles and an axle that large you'll need to have a shop place that order for you. For the hub/drums you'll need part # 8-285-10UC3-A for 5/8" studs or part # 8-285-9UC3 for 9/16" studs.

Attached are some review videos for you to check out.

expert reply by:
0
Jon G

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>