How To Perform The Zero Point Calibration On Lippert Ground Control 3.0 LC358590
Updated 11/08/2021 | Published 11/06/2021 >
Question:
When performing a zero point calibation, are the rear leveling system of the LIPPERT system also require leveling with a manual hand level ? or only the front jacks ?
asked by: Ron M
Helpful Expert Reply:
When setting up the Lippert Ground Control 3.0 Leveling System # LC358590 and performing the zero point calibration, you will indeed want to make sure the front and rear jacks are level with a hand level, or similar device. This will be what the system recognizes as its most level position, so it is important to get it as level as possible.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: How Can I Lock My Watchdog Power Center Surge Protector and Voltage Booster to Pedestal?
- Q&A: Will Turn Signals Activate Side Cameras of Furrion Vision S+ System
- Q&A: Do Lithium Batteries Need to be In Different Compartment from Inverter
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Lippert Ground Control 3.0 Leveling System For A Prepped Forest River Wolf Pack 315PACK12
- Q&A: Replacement Control Module for Lippert Ground Control 3.0
- Q&A: Troubleshooting External Sensor Error On Lippert Ground Control 3.0 LC358590
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Sidewinder with Rotating Turret for Short Bed Pickups



