Can Fulton XLT Trailer Jack be Used in Place of Fulton Magnum

Question

Question:

Is this a direct replacement for the Fulton Magnum series trailer jack?

asked by: Will

0

Expert Reply:

Yes the Fulton XLT part # F141132 that you referenced would bolt right up in place of a Fulton Magnum series trailer jack like what you mentioned.

expert reply by: Jameson C

0

Answer 1

Hello Jim, The Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K #FTJ120W0301 is rated for 1,200 pounds. Keep in mind that this rating applies to the tongue weight of the trailer, not the overall trailer weight. For…

view full answer...

Answer 2

The Fulton Bolt-Through Swivel Jack, part #F1411300301 will allow you to use the existing bracket welded to your trailer frame. The jack has a 1500 lb lift capacity, so if your trailer's tongue weight is less than that amount, it'll work…

view full answer...

Answer 3

The only trailer jack that will work with your existing mounting bracket and not contact the boat with a full rotation of the handle is the Fulton Bolt-Thru Swivel Marine Jack part #F1411300301. I understand this does not have the sharkskin coating…

view full answer...

Answer 4

The mounting holes on the Fulton XLT Bolt-Thru Swivel Trailer Jack part #F141133 are spaced 5-1/2" apart left to right as you can see in the attached photo.

view full answer...

Answer 5

Thank you for providing the picture of your existing mount. This was helpful to idenfication and I have attached it to this post. As you mentioned, the 90 degree snap in holes are 3" apart from center to center. It may be helpful to note that…

view full answer...

Answer 6

Without knowing the part number and manufacturer of your current trailer jack, I couldn't speak to the compatibility of the mounting plate for your current jack with the mount that the Fulton #F141132 XLT uses. The #P9012-00 weld-on mount for the…

view full answer...

Answer 7

Hey Adam, thanks for the information. The Dexter Brake Actuator with Manual Lockout item #T63FR is going to be a pretty comparable replacement to your Titan Aero-6000. It works with a 2" hitch ball, fits a 3" wide tongue, and has a 7,500…

view full answer...

Answer 8

Thanks! I attached the picture you submitted so that other customer can see what the Fulton F2 part #F1413140334 looks like installed on Ranger RT188 trailer.

view full answer...

Answer 9

Here is a Dutton-Lainson Round Swivel Jack #DL22335 it has an extra wide 3 inch wheel so it'll be easy to move around in any terrain and it will swing up to get out of the way. It fits frame sizes from 3 inches to 5 inches and has a 1,500 lb…

view full answer...

Answer 10

Yes, the Fulton XLT Bolt-Thru Swivel Trailer Jack #F141132 that you referenced is designed to fit the same style of mounting bracket that you have in the picture you submitted. This jack will bolt right up.

view full answer...

Can Fulton XLT Trailer Jack be Used in Place of Fulton Magnum

Continue Researching