What Is The Best Way To Cut A Mud Flap To Size.
Published 10/05/2021
Question:
What’s the best way to cut roadmaster roadwing mud flaps.
asked by: Darryl L
Expert Reply:
I would start by measuring from the top of the cross bar to the ground on the RoadMaster RoadWing Removable Mud Flap System for Full Size Trucks - 77" # RM-4400. Then using some painters tape mark the mud flap about 1-2 inches from the ground. Now take a utility knife or a razor and making several light cuts or slices work your way through the mud flap taking your time and using proper protective gear like gloves and safety glasses.
Once you are about half way through you can begin to fold the mud flap at the cut and that will help you make better cuts and speed up the process.
It is a harder material and you will need to take your time so you do not hurt yourself.
I linked a video that will also walk you through the cutting process.
Product Page this Question was Asked From
RoadMaster RoadWing Removable Mud Flap System for Full Size Trucks - 77" Wide
- Mud Flaps
- Universal Fit
- Rear Pair
- Single
- No-Drill Install
- Hitch Mount
- 24 Inch Wide
- Rubber
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: rv jack pads
- Search Results: snappad rv jack pads
- Shop: SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Blue - Qty 1
- Video: Review of SnapPad RV Jack Pads - Universal Leveling Block and Jack Pad - SN84VR
- Shop: SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Purple - Qty 1
- Shop: SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Black - Qty 1
- Shop: Roadmaster Rear Anti-Sway Bar - 1-1/2" Diameter
- Shop: Hellwig Rear Anti-Sway Bar - 1-1/2" Diameter
- Video: An In-Depth Look at the Hellwig Rear Anti-Sway Bar-HE78RR
- Search Results: sumo spring
- Shop: Suspension Enhancement
- Shop: Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets
- Shop: Roadmaster Front Anti-Sway Bar - 1-3/8" Diameter
- Q&A: Recommendations To Improve Ride Quality on a 2023 Thor Freedom Elite On Ford E-450 Cutaway Chassis
- Q&A: Comparing SumoSprings Kits SSR-130-54 and SSR-130-47 for 2021 E-450 Class C Motorhome
- Video: 2018 Ford E-Series Cutaway Roadmaster Rear Anti-Sway Bar: Complete Installation
- Video: 2019 Ford E-Series Cutaway Roadmaster Rear Anti-Sway Bar: Complete Installation
- Video: DIY 2018 Ford E-Series Cutaway Installation for the Roadmaster Front Anti-Sway Bar
- Video: Installing the Roadmaster Rear Anti-Sway Bar on your 2014 Thor Freedom Elite Motorhome
- Video: Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets Spec Review
- Q&A: Replacement AC Unit for Dometic Air Conditioner
- Q&A: How Far Does Aluma-Tow 360 Adjustable Ball Mount Stick Out From Receiver?
- Q&A: What is the Difference Between the MORryde CRE3000 and AllTrek 4000 Suspension Kits
- Q&A: What Spacing is Required for Installation of BulletProof Hitches Adjustable Mud Flap System
- Q&A: Distance from the Center of the Pin Hole to the Center of the Ball
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What is the Best Trailer or RV Storage Cover
- Article: How to Accurately Measure Trailer Leaf Springs
on Mud Flaps
