Retracting The Cable For The Lippert ToyLok Retractable Cable Lock

Question

Question:

If the cable will not retract is there anything you can do to make it roll back up?

asked by: Debbie P

0

Expert Reply:

To retract the cable on your ToyLok Retractable Cable Lock # LC337120, extend it until no clicking sound is heard. If you notice dirt or moisture on the cable clean it before retracting.

Allow the cable to retract back into the housing.

It may be necessary to guide the cable slowly into the housing in some situations.

NOTE: ToyLok has a built-in safety feature which slows the cable as it retracts.

If you no longer hear the clicking noise as the cable is extended then the internal mechanism is damaged and the ToyLok needs replaced.

expert reply by: Bud M

0

Answer 1

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 2

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 3

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

There isn't anything out there that's going to prevent theft of a Portable Solar System like #34282610. The best you can do is try to make it as hard as possible for a potential thief to steal the panels, but if someone is determined, they…

view full answer...

Answer 6

Hello Tim, Are you asking if you can back up with just the head installed on the Weigh Safe True Tow Weight Distribution Hitch #WS79VR, when you put the trailer coupler onto the ball? If so, then yes because at that point it is really just a ball…

view full answer...

Answer 7

There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy…

view full answer...

Answer 8

Hi Kevin; the Provider ST205/75R15 Radial Trailer Tire #TA55RR is manufactured somewhere in Asia. More than likely China, but there are several possible facilities it could come from. These tires are produced using the same type of manufacturing…

view full answer...

Answer 9

If you install new 225/75-15 tires on your trailer or any trailer for that matter with a load range E rating like part #LHWL304 for example then you will need to fill them to the max psi listed on the sidewall which for this tire is 80 psi. This will…

view full answer...

Answer 10

In regards to the Redarc Tow-Pro Liberty Brake Controller part ##RED24FR, the unit should not be illuminated while driving without a trailer. If you press the button while a trailer is not attached you should see a breathing blue light and that…

view full answer...

Answer 11

I recommend using the Malone EcoLight Sport Trailer with J-Style Carriers #MAL93FR for your Old Town PDL 120 kayak. Looking at the owners manual for your kayak they do recommend storing the kayak on its side rather than on the hull. These carriers…

view full answer...

Retracting The Cable For The Lippert ToyLok Retractable Cable Lock

Product Page this Question was Asked From

Continue Researching