bing tracking image
Q & A Icon

Installation of Redarc Tow Pro Elite Brake Controller for 2020 Toyota Tacoma  

Question:

I have a 2020 Toyota Tacoma, and wanting to install the Redarc Tow Pro Elite brake controller. After reading a lot about them, I am still confused about which switch plate and wiring harness I need.

0

Expert Reply:

The correct wiring harness needed for connecting the Redarc Tow-Pro Elite Trailer Brake Controller, # RED44FR, to your 2020 Toyota Tacoma, is the Plug-and-Play Wiring Harness # RED99FR. I suggest then using the Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob, # 331-TPSI-007 to mount in your dash for what will look like a factory installation. This is confirmed to fit on the left-side dash of your 2020 Tacoma uising one of the knock-out switches. Note the attached image.

expert reply by:
0
Michael R
Redarc Trailer Brake Controller Control Knob
Redarc Trailer Brake Controller Control Knob
(click to enlarge)

Michael R.

9/17/2021

The correct wiring harness needed for connecting the Redarc Tow-Pro Elite Trailer Brake Controller, # RED44FR, to your 2020 Toyota Tacoma, is the Plug-and-Play Wiring Harness # RED99FR. I suggest then using the Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob, # 331-TPSI-007 to mount in your dash for what will look like a factory installation. This is confirmed to fit on the left-side dash of your 2020 Tacoma uising one of the knock-out switches. Note the attached image.

Products Referenced in This Question



Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>