How Does Cover of Solera Power Awning Head Remove
Published 09/14/2021
Question:
I just purchased solera electric awning rails to replace carefree rails. This is a stupid question but how do you separate the covers to the plastic head covers. There are no screws but their is two slots on one side of the head cover. Looks like you can put a small screwdriver in there and they would separate but I am afraid I will break it. Thanks.
asked by: Donald W
Expert Reply:
To remove the cover of a Solera power awning head # LC289561 you do need to insert a slot screwdriver into the slots you mentioned to gently pry the cover off. The trick is to go slow and not force anything and you won't break anything.
Product Page this Question was Asked From
Replacement Back Cover for Solera Power and Crank-Style Manual RV Awnings - Plain Drive Head - Black
- Accessories and Parts
- RV Awnings
- Head Parts
- Standard Head
- Head Cover
- Solera Replacement
- Drive Head
- Black
- Lippert
more information >
Continue Researching
- Q&A: Replacement Plain Drive Head Front and Rear Covers for a Solera 2000 Series 12V Power Awning
- Q&A: Do You Have a Furrion Chill Cube AC Unit w/a Heat Pump?
- Q&A: Reason Why Furrion Chill Cube w/ Heat Pump Isn't Backwards Compatible With 2024 And Earlier Systems
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Solution for Needing Replacement Idler Head Slip Ring Assembly
- Q&A: Availability of Light Similar to Thin-Lite 766 for 2007 Winnebago Journey Motorhome
- Q&A: How To Remove Solera Awning Head Covers
- Q&A: Solera Idler Head Front and Rear Covers
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Install an RV Awning From Scratch
- Article: How to Replace a Rubber RV Roof
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure a Trailer Axle
- Article: How to Replace or Install an RV Roof Vent