SoftStartRV Soft Start Wiring for Dometic Brisk Air Wiring Diagram

Published 09/04/2021

Question:

I purchased the a/c soft start and am trying to find the wiring diagram for the picture I’ve included.

asked by: Jeremy M

Expert Reply:

I attached a picture of the wiring diagram found on your Dometic Brisk Air AC unit.

To install you will remove the white wire coming from the compressor to the run capacitor and connect it to the blue wire on the SoftStartRV.

Next take the black wire from the SoftStartRV and connect where the white wire was on the run capacitor.

The yellow SoftStartRV wire will connect to the red wire at the run capacitor that goes to the compressor. If there is a 2nd red wire going to the start capacitor it must be removed and taped up at the run capacitor end.

Now remove the compressor cap and disconnect the blue wire then connect to red wire from SoftStartRV.

Connect Brown SoftStartRV wire on terminal blue compressor wire was on. Route bwn wire toward white compressor wire and replace compressor cap.

You can now secure all the wires in place and test your unit.

expert reply by: Bud M