Replacement Trailer Strip LED Taillights for Stop/Tail/Turn 2015 ATC Quest Trailer
Updated 08/25/2026 | Published 08/31/2021
Products Featured in This Question
Question:
Hello I have a 2015 ATC quest trailer and I am in the process of replacing the lights I will need 328-003-19R reds and ambers But I would like to replace the brake lights that are combo signal lights as well It is a strip LED with chrome ends I have photo if needed can you assist Thank you
asked by: Sean R
0
Expert Reply:
The closest taillight solution we have to what you are looking for would be the part # STL264RCB which is a stop/turn/tail light that is an LED strip that measures 20-1/2 inches in length.
expert reply by:
Jameson C
0
Strip Taillight
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
LED Trailer Clearance or Side Marker Light with Chrome Bezel - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 3-1/4L x 1-13/16W Inch
- Red
- Command Electronics
more information >
Continue Researching
- Search Results: 17200
- Search Results: curt 17200
- Search Results: trailer jack
- Search Results: power tongue jacks
- Search Results: wireless tow lights
- Search Results: temporary tow lights
- Shop: Fusion LED Combination Tail Light Bar for Trailers over 80" Wide - Submersible - Clear Lens
- Video: Review of etrailer Trailer Jack - Dump Trailer - Enclosed Trailer - Utility Trailer - e73QV
- Search Results: ram coupler
- Shop: Grille Guard
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Camper Tie-Downs
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Shop: etrailer Hydraulic Trailer Jack - Square Tube - External Pump - 20" Lift - 8K lbs - Direct Weld
- Shop: etrailer Hydraulic A-Frame Trailer Jack - External Pump - 20" Lift - 7,000 lbs - Bolt On
- Shop: Optronics Mini Side Marker and Clearance Light - Submersible - 3 Diodes - Clear Lens w/ Red LEDs
- Shop: Optronics Smoke Lens ID Light Bar - Turn, Brake, Tail, and Backup Light - Red/White - 20-1/2"
- Shop: Leaf Spring Bushing - Bronze - 1.74" Long x 0.70" OD x 0.58" ID - Qty 1
- Q&A: Replacement Electric Jack for ATC Quest CH405 Car Trailer
- Q&A: Recommended Weight Distribution Hitch for a 7,000 lbs Short V Nose Trailer
- Q&A: U-Bolt Torque Recommendation for 1/2 inch Diameter On Trailer Suspension
- Shop: Floor Mats
- Shop: Gooseneck Hitch
- Shop: Brake Controller
- Q&A: Nut and Washer Size For Installing Trailer Brake Assemblies # AKEBRK-35-SA
- Video: Breaking Down the Foam Gasket for MCL13 Series LED Lights
- Video: Hands-On with the Thinline LED Trailer Tail Light
- Video: Ultimate Overview of the Optronics Mini Side Marker and Clearance Light
- Q&A: How to Change Battery Mode on Progressive Dynamics 9300 Series RV Converter Charger
Steve
8/25/2026
I have this identical trailer setup as the above photo. The measurement of the light is 20 1/2" x 1". It only has the black, white and red wire. The part number STL264RCB shows to be 80" wide and has a fourth, yellow wire. I need 20 1/2" x 1" with the white, red and black (running, turn and brake lights). Do you have a part number for that?