Progressive Dynamics 4000 Series Converter that is Compatible with Lithium Batteries
Published 08/12/2021
Question:
Need to know if this replacement board includes the special switch to correctly charge LiFePO4 lithium batteries??
asked by: Ron O
0
Expert Reply:
The part # PD4060CSV that you referenced is compatible with lithium batteries as there's a small switch on it that allows it to change between the two. It has a tiny microswitch right near the coil that has two positions, one marked LA (lead acid) and the other marked LI (lithium).
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 60 Amp Power Center
- Accessories and Parts
- RV Power Converter
- Converter Section
- 60 Amp
- Progressive Dynamics
more information >
Continue Researching
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Q&A: Can the Converter Section of a PD4045KA Be Upgraded to 60amps and Charge Lithium Batteries
- Q&A: Replacement Converter Section for Progressive Dynamics PD4060K for Lithium Batteries
- Q&A: Do You Have to Replace the Converter Section of a PD4590 Power Center For Lithium Batteries
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Need Correct Replacement Converter Section For PD4560WJ 4500 Series Power Center
- Q&A: Do I Need to Install a Jumper Wire On the H4 Connector When Switching From Lead to AGM Batteries?
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Flat Towing Package for 2025 Jeep Wrangler
- Article: Converting Your RV Water Heater to Tankless
- Article: Can You Flat Tow a 2025 Chevy Trax?
- Article: Best RV Roof Vents