Replacement Surge Trailer Coupler for Military Trailer

Question

Question:

do you happen to know the dimensions between the mounting bolts?

asked by: JOHN L

0

Expert Reply:

Thanks for the picture of the coupler you have on your military trailer. Based on that I can tell what you have is a Model 6 and the same as the Titan part # T4093200 that you referenced so it would bolt right up.

expert reply by: Jameson C

0

Distance between bolt holes
(click to enlarge)

Military Trailer Coupler
(click to enlarge)

John D.

8/13/2021

do you happen to know the dimensions between the mounting bolts?

Jameson C.

8/13/2021

I attached a picture that has the distance between the Model 6 mounting bolts. It's a different coupler style but the main body of the actuator is the same.

Answer 1

I went out to our warehouse and took a measurement of the mounting holes of the Replacement Master Cylinder Assembly #T1777405. The part that you referenced, #T1027100, was out of stock, but the whole replacement assembly we do have in stock. From…

view full answer...

Answer 2

The springs on the side of the Replacement Master Cylinder Assembly for Titan Model 6 Brake Actuators part #T1777405 are designed to pull the bracket and plunger back into position when applying the brakes in your tow vehicle to release the brake…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Replacement Surge Trailer Coupler for Military Trailer

Product Page this Question was Asked From

Continue Researching