What is Amperage Draw of Advent Air RV AC unit part # ACM135C

Question

Question:

what is the running amps on high speed fan cooling? 2. What is the sound level in decibels?

asked by: Tommy L

0

Expert Reply:

The Advent Air RV AC unit part # ACM135C draws a max of 15 amps when in full use, the compressor when running draws 9.9 amps and if the fan motor was just running would draw 2.6 amps. The decibel rating is 76.

expert reply by: Jameson C

0

Answer 1

Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…

view full answer...

Answer 2

The only thermostat option we offer for the Advent Air RV Air Conditioner #ACM150 is apart of the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners #ACRG15, which also includes an air distribution box. The wall…

view full answer...

Answer 3

Yes, the Advent Air RV Air Conditioner System #ACM135C will come with everything needed, besides tools and wing nuts/butt connectors for the wiring. This system works with both ducted and ductless systems so it will work with your current setup. The…

view full answer...

Answer 4

So there's a few things that are going to be needed in order to install the Advent air conditioners, and for a tent trailer I do recommend going with the smaller 13,500 Btu. But the first thing you need to do is ensure you have a roof that is…

view full answer...

Answer 5

The Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor - 13,500 Btu - White #ACM135C will come with the roof gasket. The only items you may need are some wire nuts, electrical tape, and possibly some additional wire if you…

view full answer...

Answer 6

The Advent Air RV Air Conditioner System #ACM135C clamps to the roof of the RV using four bolts that pass through the air distribution box, up through the 14" x 14" cutout hole and thread into the weld nuts in the rooftop unit. This portion…

view full answer...

Answer 7

I attached a picture that has all of the dimensions of the Advent Air Conditioner unit part #ACM135C relative to the vent opening that you asked about. From the front of the unit to the front of the vent opening measures 5-1/4 inches.

view full answer...

Answer 8

Yes, the installation instructions that came with your Advent Air RV Air Conditioner System #ACM135C are correct. You tighten the bolts to 40-50 inch pounds. This compresses the gasket to approximately 1/2". Since the bolts are self locking,…

view full answer...

Answer 9

No, it is not necessary to use sealant when installing the Advent Air Rooftop RV Air Conditioner #ACM135C on your trailer. This unit is designed so that is not necessary because it has a thick gasket that prevents water from leaking in. I have added…

view full answer...

Answer 10

For your application I recommend going with a Furrion Chill HE AC unit. This comes with a wiring adapter that allows you to connect straight into your current Dometic wiring and use all of those controls. To replace your 13.5K Btu unit you'll…

view full answer...

Answer 11

The Advent Air Conditioner part #ACM135 has a running amperage draw of 15 amps and a starting amperage draw of 45. If you were to use the Start Capacitor for Advent Air RV Air Conditioners #ACMSCKIT too then the start amperage draw would drop down to…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

What is Amperage Draw of Advent Air RV AC unit part # ACM135C

Continue Researching