Furrion Tankless Water Heater to Replace Atwood GC6AA-9E

Question

Question:

Does the above fit in the opening of an Atwood GC6AA-9E which I am replacing? Also, which door do I Order? Thanks!!!

asked by: Tom L

0

Expert Reply:

The Furrion part # FR93FR is close enough to the dimensions of your Atwood GC6AA-9E that it would work great. For a door you'd just need the part # FR43FR.

expert reply by: Jameson C

0

Answer 1

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.

view full answer...

Answer 2

Yes, you can replace your Atwood GC6AA-9E with a tankless water heater. You could use the Furrion RV Tankless Water Heater #FR98SR, which has measurements of 12-5/8" wide x 12-5/8" tall x 19-1/4" deep which is going to be close to what…

view full answer...

Answer 3

When it comes to a replacement for your Atwood Water Heater GC6AA-9E The Dometic RV Water Heater #DMC74FR will be a replacement. This system has a 6 gallon tank and has both a automatic direct-spark gas pilot and an internal electric heating element.…

view full answer...

Answer 4

The Dometic RV Water Heater part #DMC74FR will work great as a replacement for an Atwood GC6AA-9E. They are both gas and electric with a six gallon tank. It will allow you to reuse the existing door already on the trailer. The swap should be pretty…

view full answer...

Answer 5

I recommend checking out the Dometic RV Water Heater - Gas and Electric - Automatic Pilot #DMC74FR for a replacement for your Atwood GC6AA-9E. This water heater is a direct replacement for your current water heater, produces up to 12 gallons of hot…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Furrion Tankless Water Heater to Replace Atwood GC6AA-9E

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching