Replacement Actuator for Titan BrakeRite Part # 4822500

Question

Question:

Hi I need to replace my 10 year old Brakerite #4822500 1,000psil, Drums can you recommend a replacement unit? I only see units for disc brake applications. Thanks

asked by: Mike D

0

Expert Reply:

The part number you mentioned corresponds with a brake actuator that is no longer around but for a replacement the best performing and most reliable drum brake actuator is the Hydrastar # HBA-10 which is the same 1,000 psi rating.

expert reply by: Jameson C

0

Answer 1

I have attached the wiring diagram for the Titan BrakeRite EHB Electric-Hydraulic Actuator #T4822500 that you referenced. This particular actuator is designed for use with hydraulic drum brakes and features 1,000 psi of hydraulic pressure. I have…

view full answer...

Answer 2

Your 2023 Chevy Suburban RST does come with the factory tow package so there would be a harness under the d ash near the emergency brake pedal that the part #3016 would plug into. This would allow you to use a brake controller like our very popular…

view full answer...

Answer 3

For a brake controller I really like the Prodigy P2 part #90885 as it's basically the gold standard for brake controllers. It is super reliable, gives you the best braking performance, and has yet to be improved upon basically. It would wire…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Rob. The Spacer Kit item #RP61301 will allow you to install the Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter item #RP85FR on a Lippert 1116 pin box. You can also purchase the Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride…

view full answer...

Replacement Actuator for Titan BrakeRite Part # 4822500

Products Featured in This Question

Continue Researching