Where Do Reverse Lockout Solenoid Wires On Titan Surge Brake Actuator T4750620 Get Connected?
Updated 05/20/2021 | Published 05/18/2021
Question:
has two wires ... does one go to backup lights and the other to ground?
asked by: Dean B
Expert Reply:
It sure does!
The two wires for the reverse lockout solenoid on the Titan Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball # T4750620 you were looking at will be wired exactly how you mentioned.
One will get grounded to the frame of the trailer, and the other will get connected to your trailer connector and then the reverse lights of your vehicle. It does not matter which wire gets connected to which, just that both do get connected.
I included a video of the # T4750620 for you to take a look at.
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- 3 Inch Channel Tongue
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: model 10
- Shop: Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball
- Q&A: Where Do the Rubber Bearings Go On the Titan/Dico Model 10 Surge Brake Actuator
- Shop: Replacement Shock for Dexter Model 6 and 10 Brake Actuators
- Q&A: How Are Roller Bearing Installed When Replacing Shock For Titan 6 Or 10 Brake Actuators
- Q&A: Repair Kit for Titan Zinc-Plated Disc Brake Actuator for 2-5/16-Inch Balls Model T4750620
- Q&A: Replacement Master Cylinder Assembly for Titan Actuator Coupler for Disc Brakes
- Q&A: Is There a Installation Video That Will Help With Replacing Shocks On Dexter Model 10 Surge Actuator
- Search Results: model 60
- Search Results: shocks absorbers
- Search Results: t1242600
- Shop: Dexter Zinc-Plated Brake Actuator w/ Electric Lockout - Disc - 2-5/16" Ball - 8,000 lbs
- Shop: Replacement Master Cylinder Assembly for Dexter Model 60 Brake Actuators - Disc
- Shop: Replacement Front Roller Cover for Dexter Model 10 Brake Actuator
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Video: Titan Brake Actuators with Reverse Lockout Replacement Solenoid Valve Installation
- Video: Titan Brake Actuator T4748800 Review
- Search Results: dico model 10 master cylinder
- Search Results: trailer bearings
- Search Results: kodiak 225 brake pads
- Shop: Replacement Master Cylinder Assembly for Dexter Model 10 and Model 20 Brake Actuators - Disc
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Titan Surge Brake Actuator for Model 10 Part 3241639
- Q&A: Replacement Surge Brake Actuator To Replace Tie Down Model 125 12,500LB Drop Actuator
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop