Can I Use Grease To Lubricate Nylon Bushings On Trailer Leaf Springs?
Updated 05/19/2021 | Published 05/17/2021
Products Featured in This Question
Question:
Is greased required on an open eye leaf spring between the nylon bushing and the leaf spring. Ive seen differing views on this subject. To grease or not to grease.
asked by: Eric K
Expert Reply:
I never recommend using grease with Nylon Bushings # TRBU11566. The grease can trap dirt which will cause the nylon to become damaged easier. And the chemicals in different greases can cause the nylon bushings to break down.
If you want to use Grease # L11390 on your suspension system I recommend using Wet Bolts # 126B2 with Bronze Bushings # D014-077-00. This will allow you to apply fresh clean grease inside the bushing while pushing out the old grease and dirt.
Product Page this Question was Asked From
Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Trailer Suspension Parts
- Bushings
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- 9/16 Inch ID x 11/16 Inch OD
- 1-3/4 Inch Long
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: equa flex
- Search Results: curved equalizer
- Search Results: slipper spring bushing
- Search Results: trailer wire
- Search Results: rear spring hanger
- Search Results: 2500 lbs trailer leaf springs
- Search Results: deck screw
- Shop: Nylon Bushings - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long - Qty 4
- Shop: Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Q&A: Are Leaf Spring Bushings Hard to Replace
- Shop: Equalizer for 2" Wide Slipper Springs - 12" Long - 7/8" Center Hole - Zinc Plated
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Shop: 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long
- Shop: Bronze Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long - Qty 1
- Shop: Trailer Wiring
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Leaf Springs and Shackles for 2012 Eclipse Attitude Toy Hauler
- Video: Equalizer for 2" Wide Slipper Springs: The Breakdown
- Article: How to Measure a Trailer Axle
- Q&A: Can Trailer with Slipper Springs be Changed to Double Eye without Changing Hangers
- Q&A: Should There Be Play Between the Bushing and Wet Bolt of Trailer Suspension
- Q&A: Measured Dimensions of TruRyde Nylon Bushing TRBU11508
- Q&A: Can Slipper Spring Replace Existing Double Eye Leaf Spring
- Q&A: Determining If Open Eyed Slipper Leaf Spring Is Needing Replaced
- Video: A Closer Look at the Dexter Trailer Axle Beam with EZ-Lube Spindles
- Video: This Old Trailer: Electric Trailer Brake Installation Part 1
- Video: Let’s Check Out the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles
- Video: A Closer Look at the Nylon Bushing
on Trailer Suspension Parts
