Parts Needed to Install Stromberg Extend-a-Line Drying Rack At RV Rear Bumper

Updated 05/11/2021 | Published 05/09/2021

Products Featured in This Question

Mounting Post for Stromberg Carlson Extend-A-Line RV Mounted Drying Racks - Square Bumper or A-Frame

(4)

$69.95

Question:

If i buy Mounting Post for Stromberg Carlson Extend-A-Line RV Mounted Drying Racks - Square Bumper or A-Frame - CL-01 What is the part nr for the drying rack to attaches to it? the one with multiple arms. Its not very clear. 5815-CL looks like only the arms. Not the mounting part. if that is it. DOES it mount toe CL-01? WIth no additional parts? Is this all i need to have it mount to my 4 inch bumper and have the all i need. Mounting Post for Stromberg Carlson Extend-A-Line RV Mounted Drying Racks - Square Bumper or A-Frame - CL-01 Remove 1 Update 5815-CLReplacement 42inch Arms for Stromberg Carlson Extend-A-Line RV Mounted Drying Rack - Qty 6 - 5815-CL OR is there a all in ONE i can order. I do NOT want it to mount to the LADDER i want to use the CL-01 arm off the bumper. Tks.

asked by: Joe R

Expert Reply:

To use the Stromberg Carlson Extend-A-Line drying rack on a square bumper you'd need the part # CL-01 for the portion that attaches to the bumper and then for the actual rack itself you'd want the part # CL-36 and you'd be set. The arms of this setup are going to be 19-1/2 inches whereas if you went with the part # CL-27 are 13-1/2 inches.

expert reply by: Jameson C