Availability of Mounting Brackets for TorkLift TLA 7712 Battery Box

Question

Question:

Do you also sell brackets that would fit the TLA 7712, mine on my Lance is only 20.5 inches wide and the double battery box is 24 inches? Looks like the lance bracket is held on by screws and can be removed.

asked by: Greg C

0

Expert Reply:

Torklift doesn't sell the mounting brackets as a separate item, but they are included with the # TLA7720R battery box, however it isn't absolutely necessary to use the brackets. As you can see in the linked video for the # TLA7720R battery box, we simply installed it directly into the trailer A-frame using existing holes in the underside of the box.

expert reply by: Mike L

0

Answer 1

While I don't know what the dimensions on the Patriot Power Generator 1800, I can tell you that the TorkLift PowerArmor Single Locking Battery Box #TLA7720R is 17-3/4" Long x 8-3/16" Wide x 11-1/4" Tall. If your generator is under…

view full answer...

Answer 2

I do have a possible solution for you but unfortunately there aren't any battery boxes available that will hold two 12V batteries and fit within a 21" length and 8" width. The closest thing we have is the TorkLift PowerArmor Locking…

view full answer...

Answer 3

The TorkLift PowerArmor Single Locking Battery Box part #TLA7720R weighs about 15 lbs.

view full answer...

Answer 4

The TorkLift PowerArmor Solar Locking Battery Box part #TLA7700LS is not wide enough to fit two group 31 batteries. Group 31 batteries are 13" long by 6.72" wide by 9.44" tall. The only option that's big enough is the Commercial…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 9

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 10

Hi JD; the Furrion Chill Cube #FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system. Assuming you have a ducted system you will need…

view full answer...

Answer 11

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 12

If you install the Correct Track Trailer Alignment and Lift Kit #RR23QX it will require longer bolts but MORryde makes a kit specifically for this. To find the right MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track you will…

view full answer...

Availability of Mounting Brackets for TorkLift TLA 7712 Battery Box

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching