Is it Okay to Just Replace Bearing in Trailer Hub without Race
Updated 02/25/2021 | Published 02/24/2021
Question:
If the race looks fine, is it ok to just replace the bearing? Or is it recommended to do both at the same time? These are on a utility trailer with a 3500# axle.
asked by: Charlie
1
Helpful Expert Reply:
If the race is fine you are totally okay to just replace the bearings. In most situations just replacing the bearing is all that's needed.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Article: Trailer Wiring Diagrams
- Q&A: Does Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 Have Ceiling Garnish
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Dexter Vault Hub Service Kit Replacement Kits