Install Harness for 2005 Chevy Tahoe for Curt Spectrum Brake Controller

Question

Question:

For installing a Curt Spectrum 51170 trailer brake controller in a 2005 Chevy Tahoe is C51352 the correct wiring adapter?

asked by: Dave T

0

Expert Reply:

Yes the correct brake controller install harness for your 2005 Chevy Tahoe is the part # C51352 to install the Curt Spectrum # C51170 that you mentioned.

expert reply by: Jameson C

0

Answer 1

Hey Don, as long as you have a 7-way on your truck then you can use the Curt Spectrum #C51170. The 7-way being already there means all of the necessary wiring to use this brake controller has been run so you'll be all set! Let me know below if…

view full answer...

Answer 2

It sounds like the red wire in the wiring harness #C51352 was not in the correct place. Take a look at the picture I have included and make sure that the wires in your harness are in the same places. This is the end that plugs into the truck. It…

view full answer...

Answer 3

If it's just a 4-Way Flat connector like the T-On #118786 then I would be surprised to see that much power being pulled to the back of your 2020 Jeep Wrangler Unlimited, but if you have a 7-Way like what we find with the Wiring Kit #ETBC7 then…

view full answer...

Answer 4

Yes, the Aluminum Sendel Series T07 Black Machined Trailer Wheel #AM97XR will work with your 205/75R15 tires. The 205/75R15 tire will fit rim widths of 5-inch, 5-1/2-inch, 6-inch and 6-1/2-inch and the #AM97XR are 6-inch. From what I can find on the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Install Harness for 2005 Chevy Tahoe for Curt Spectrum Brake Controller

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching