Replacement Jack for 1996 Mastercraft Prostar 190 Trailer

Question

Question:

1996 Mastercraft Prostar 190 trailer. Jack is beginning to bind up so looking for a replacement this winter. Is there a direct bolt on replacement to the current mount?

asked by: Cleve P

0

Expert Reply:

While we do have replacement jacks that will work for your 1996 Mastercraft Prostar 190 trailer, there are none that are going to be a direct bolt-on replacement for the bracket you currently have on. So what you will need to do is use a bolt-on jack like the Fulton Bolt-Thru Swivel Marine Jack - 12" Lift # FXP15L.

expert reply by: Kyle S

0

Answer 1

The direct replacement for your Dutton-Lainson 203925B jack would be part #DL22560. According to Dutton-Lainson, the jack would indeed be compatible with your existing mounting plate. I've linked to a product demonstration video featuring the…

view full answer...

Answer 2

The correct grease seal for your Mastercraft boat trailer is part #010-180-00. It has an inner diameter of 1.68" and an outer diameter of 2.33" to match the dimensions your mentioned required for your trailer axle. You can then purchase the…

view full answer...

Answer 3

Yes! For a boat jack that is similar to the #DL67MR that provides you with the smaller capacity you need, that is the Swivel Marine Trailer Jack with Caster Wheel - Bolt On - Sidewind - 10" Travel #DL84MR. The bracket height from the top of the…

view full answer...

Answer 4

It sounds like you may be wanting to replace just the coupler portion of the actuator. Typically the best option for a surge brake actuator with a bad coupler, is to replace the entire actuator. To replace just the coupler, I would need to know the…

view full answer...

Answer 5

Hey Dennis, thanks for the dimensions of your grease seal. Based on that the correct replacement would be the part #010-180-00.

view full answer...

Answer 6

From the research I did the Kodiak 225 calipers like the part #KDBC225DAC that you referenced are an exact replacement for the Mastercraft setup you currently have.

view full answer...

Answer 7

The best way to find the bearing numbers of your trailer is to pull the hubs and read the numbers on the current ones or measure the spindles where the bearings sit. You may be able to find a tag or stamp on the axles and use it to find information…

view full answer...

Answer 8

Unfortunately, we don't offer a jack that would be compatible with your existing weld-on bracket. Atwood went out of business awhile back and their products are no longer available. I'd recommend having the existing bracket removed and…

view full answer...

Answer 9

The standard ratio we use for selecting a boat trailer winch is 2:1 which means the winch at a minimum needs to be rated for half the weigh of the boat. The Fulton 2-Speed Trailer Winch part #F142425 is a great option with enclosed housing and…

view full answer...

Answer 10

From my research it appears MasterCraft specifies Kodiak disc brakes on their tandem boat trailers so you'll just want to confirm the axle rating. Then just review the linked page that displays all Kodiak replacement pads like the part #K225CP…

view full answer...

Answer 11

It sounds like you're using our system to look up both the tire and wheels as opposed to just wheels. Your ST215/75R14 tires will install on 14" wheels and out of our linked selection I recommend checking out the Aluminum Sendel Series T07…

view full answer...

Answer 12

The first thing we need to know is what kind of brakes you have on your trailer. For brakes you need to let me know what size and type brakes you have on your trailer. I have attached a couple helpful articles that explains what is needed when adding…

view full answer...

Replacement Jack for 1996 Mastercraft Prostar 190 Trailer

Continue Researching